Wheely King (need help)

[rcguymike]

Hey everyone! I have an issue with my Wheely King. I ran it a few times in the snow and it ran fine for the first hour or two then it suddenly quit. I can't figure out what's wrong. The steering servo still works but I can't get any respose out of the motor. I know it's not the reciever because I switched the wires and the throttle controled the steering but the steering would not run the motor. Any help would be appreciated.

Thanks

[pedeboi364]

ESC or motor are shot... hopefully the ESC lol

[jonelzoe]

yah did you check those yet

[JeLeAk]

you prob go the esc wet, it might work if you really dry it out

[master_of_desaster]

yeah dry the esc...you can also( if you have another esc around) hook up another esc to the motor and try to run it...if motor dont run then the esc is shot.

[pedeboi364]

u can try to use WD-40 to get some water out if it's not already dead...

[rcguymike]

Thanks for the replies. I also took the 20 amp fuse out and then nothing worked until I put it back in. Would that mean the esc is fine? Also if I were to unhook the motor could I test it with a 9volt or would that be to much voltage or to less?