Kyosho Infreno GT (Picco Power)

[bill9]

It will run in the mid 60's at around 260deg. 30% fuel

Picco P3-28
Sullivan tiger drive starter
Kania 3 aluminum(blue shoe) clutch/15/19 pinions
Ofna 086 Top end pipe
Integy air filter
Mc-9 plug
JAC 30% fuel

Factory universals (all 4 corners)
Factory universals (front & rear center shaft)
Factory ST-R brake disk/Acre pads
Factory 2.5 front sway bar
Factory 2.8 rear sway bar
Racers edge screw kit
Lundsford turnbuckles
Factory carbon fiber parts
GRP tires/wheels

Ofna 1400 receiver pack
Ofna fail safe
Futaba T3 pm-fs radio/receiver
JR 590 servos
Dubro aluminum servo arms




http://i65.photobucket.com/albums/h238/bill9/IMG_2005.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1926.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1928.jpg

[Kevin Trudel]

I have the same exact car!! They are so fun! Except yours is a little more tricked out then mine is.. LOL.

[bill9]

I have the same exact car!! They are so fun! Except yours is a little more tricked out then mine is.. LOL.


Not allot of people bought the Calsonic body style..at least not in my area...I'm looking for a carbon fiber wing..

[bill9]

I have the same exact car!! They are so fun! Except yours is a little more tricked out then mine is.. LOL.


Kevin,
I'm new to this forum, and have not had allot time to investigate it...are there any threads about the IGT??

[Kevin Trudel]

You are the first start the thread on the IGT! For a Ready-To-Run, it's one of the funnest cars I've run on-road.

[bill9]

I started a thread in alternate RC...I guess that the right spot???