bill9
05-01-2007, 11:56 AM
I'm new to this forum and not sure if this in the right spot. Moderator..
Point me in the right direction if needed.
This car will run in the mid 60's at about 260deg/w 30% fuel.
I have had more fun with this car than any of the other RC car I've ever had..and there have been quite a few.
Picco P3-28
Sullivan tiger drive starter
Kania 3 aluminum(blue shoe) clutch/15/19 pinions
Ofna 086 Top end pipe
Integy air filter
Mc-9 plug
JAC 30% fuel
Factory universals (all 4 corners)
Factory universals (front & rear center shaft)
Factory ST-R brake disk/Acre pads
Factory 2.5 front sway bar
Factory 2.8 rear sway bar
Racers edge screw kit
Lundsford turnbuckles
Factory carbon fiber parts
GRP tires/wheels
Ofna 1400 receiver pack
Ofna fail safe
Futaba T3 pm-fs radio/receiver
JR 590 servos
Dubro aluminum servo arms
http://i65.photobucket.com/albums/h238/bill9/IMG_2005.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1926.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1925.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1928.jpg
Point me in the right direction if needed.
This car will run in the mid 60's at about 260deg/w 30% fuel.
I have had more fun with this car than any of the other RC car I've ever had..and there have been quite a few.
Picco P3-28
Sullivan tiger drive starter
Kania 3 aluminum(blue shoe) clutch/15/19 pinions
Ofna 086 Top end pipe
Integy air filter
Mc-9 plug
JAC 30% fuel
Factory universals (all 4 corners)
Factory universals (front & rear center shaft)
Factory ST-R brake disk/Acre pads
Factory 2.5 front sway bar
Factory 2.8 rear sway bar
Racers edge screw kit
Lundsford turnbuckles
Factory carbon fiber parts
GRP tires/wheels
Ofna 1400 receiver pack
Ofna fail safe
Futaba T3 pm-fs radio/receiver
JR 590 servos
Dubro aluminum servo arms
http://i65.photobucket.com/albums/h238/bill9/IMG_2005.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1926.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1925.jpg
http://i65.photobucket.com/albums/h238/bill9/IMG_1928.jpg