mo985
08-28-2008, 01:49 PM
My AD2 was working fine, then just up and stopped, my friends dad was driving it at the time. Anyway, I checked out the clutch, spur gear and slipper, everything is good, tighented the two halves of the diff up, but does the actual diff have a slipper set up in it? The rear wheels turn when sitting on the starter box, but when the weight of the truck is on them, all the visible stuff, clutch bell, spur gear etc... turn fine but the truck will not go. I re-read the section in the owners manual about adjusting the slipper clutch, and with holding the right rear wheel, and spur gear I can still turn the left wheel. I've gotten my tranny removal down to like 15 mnutes but wanted some other advice before I tear into it again.
Thanks!!
Thanks!!