Slash Set-up

[slim slash]

Up front: Integy shocks with one hole piston and 50 weight oil. Mount the shocks on the outer hole. I used the Integy blue springs. I set my A-arms at level. For a servo I use the JR 4400s.

Out back: Integy shocks with two hole pistons and 60 weight oil. Mount the shocks in the second hole from the outside. I used the red Integy springs. The ride height is set so the drive shafts point down just a liitle from level.

Gearing : I use 19t motor. So I use a 90 spur and a 18 pinion. Good speed and It has very good pull.

[Fiero_Man_121]

nice setup, you need to gear that suker up though, try 23/86 se how it goes.

[slim slash]

Thanks, The local track that I run only has about a 30' front strech. I don't want to get the motor too hot. I will try something close to that . 20/86

[Maxx man]

sweet sounds pretty nice! lol myns stock right now in its set up I only have one middle spacer on the front (wich I need to ad another) and the large middle and small on the back its still pretty soft (especially up front but it looks cool and all I do is bash right now its no big deal)

[Lyric]

a vxl is not stock

[Maxx man]

oh ya that to:p

[LSXEric]

Front shocks: 45wt oil 10mm pre load.

Rear shocks: 55wt oil 7mm pre load.

Power plant: Stock motor and ESC, 7 cell 4200 mah venom.

Gearing: 21/86

(Two side notes: swish cheese chassie and reversed tires.)

[slashman21]

stock shock fluids
stock camber
proline tires
3000 Mah Venom batterie

[master_of_desaster]

60wt oil seems to work well in my sc10 and my cousins slash